Ok at first when I received the Blinky tape it was working fine (lights turning on when powered, animation playing) but now its behaving incorrectly.
I power it and no lights turn on, I press the switch once the lights turn on the lowest Illumination level but no animation.
Now when I press & hold the switch the animation plays & the Illumination goes up one level, but as soon as I let Go animation stops.
Note this is the ColorSwirl loaded directly form Arduino, & I have Tryed other sketchs but all have the same weird behaviour.
I believe its a hardware problem with the switch, its as if the switch is stuck on & when pressed it turns off